D&R TELEPHONE HYBRID-2 User Manual

TELEPHONE HYBRID-2 USER MANUAL Version 1.001

Manual page 10 INSTALLATION

Manual page 11 DECLARATION OF CONFORMITY Manufacturers Name: D&R Electronica Weesp b.v. Manufacturers Address: Rijnkade 15

Manual page 12 PRODUCT SAFETY This product is manufactured with the highest standards and is double checked in our quality control department fo

Manual page 13 removing the ground wire sometimes cures a system hum, it will create a very hazardous situation for the performing musician. Alway

Technische Hinweise zum Anschluss des TelefonhybridsAnschlussbelegung RJ11/ Keine Funktion des Telefons:Manchmal kommt es vor, dass ein Telefon nicht

Technische Hinweise zum Anschluss des TelelonhybridsRJ ll-Stecker (Western-Stecker): Belegung Telefon Internationale Norm6 Kontakte (davon 4 belegt),

Technische Hinweise zum Anschluss des TelefonhybridsHier der Belerunqsplan als Gesamttibersicht1 = a-Leitungsader2 = b-Leltungsader3 = frei4 =trei5 =

Manual page 14 TELEPHONE HYBRID-2 SERVICE MANUAL

Manual page 2 Dear Customer, Thank you for choosing the Telephone Hybrid-2. This time you are not faced with a huge manual because it i

Manual page 3 D&R’s newest Telephone Hybrid-2 is the active version of the well known passive one, successfully sold over the last 5 ye

Manual page 4 Front panel lay-out CONNECT BUTTON: (RING) Line connect switch to connect and disconnect calls from the telephone line. It can be

Manual page 5 SYSTEM DESCRIPTION. A large ring button enables you to pick up the line from the unit itself or from your mixer when connected v

Manual page 6 +SETTING UP PROCEDURE Connect the two wires of the telephone line’s wall unit to the RJ-11 connector labeled LINE and connect t

Manual page 7 DUCKING The Hybrid has an automatic gain adjustment of the incoming signal from the caller when the presenter speaks. This feature b

Manual page 8 GPI GPI FUNCTION CONNECTION Tip Pull down 47 ohm to ground Ring Pull up +5 volt via 10kohm Sleeve No Not connected PHONE PHON

Manual page 9 RECEIVE Impedance < 50 Ohm, electronically balanced Common mode rejection >40dB Maximum output level +26dBu Nominal outp